Limited Production – Mitsubishi Automation E500 Series AC Frequency Inverter and keypad for 1.5kW (2HP) 230V 3 Ph motor in VxF or Vector control to 8A. Simple to set-up and converts single phase 230V input to three phase 230V for a standard AC Induction motor.
140mm Wide x 156mm Deep x 140mm high in IP20 case.
Overload – 150% x 60 Seconds and 200% for 0.5 seconds.
Speed Control Range – 0.2/400Hz.
Features – 2 x Analogue Inputs (1 x Voltage & 1 x Current), 7 Digital Inputs, 2 Analogue outputs, 1 Relay c/o Contact set and 3 digital outputs.
Programmable from the on board keypad.
EMC Filters – not included.
Input load – 4.5kVA.
Input Voltage – 200-240V single phase -15%, +10% at 50/60Hz +/- 5%.
Cubicle or enclosure mounting.
Rated at 50C Ambient.
Ventilation space above and below – 50mm.
Ventilation space at sides – 50mm.
Heat Loss at max output – XXW.
Mounting via 4 x 5mm holes on 128mm wide x 138mm high centres for rear mounting.
This has been replaced by the FR-E720S-080-EC, the wiring and nearly all the parameters are the same. The new drive will also run in open loop flux vector mode, which the S500 did not support, hence you will be getting a better drive. Some of the frame sizes of the old S500 range are still available on significant lead times.